Beam construction, prepared for lamination.

Beam after lamination, first part.

Now working on the second hull again.

It is nice to rest in the cabin, and imagine sailing, unfortunately steel a loot to do.

Storage beneath the floor, keel case in the lower right corner

Bulkheads were not made out of one piece, i didn't have the real plane, and i saved the ply.

Middle part that will stay opened

Front cabin with the roof.

Rear cabin side.

Stern.

Front cabin, outer side of the middle part that is opened.

Front cabin, door.

Inside of the back cabin.

Almost finished hull.

After completing the hull, we carried him out of the shed

 

The inside of the turned hull

Now the first hull that was standing out was brought in, and i started to pain him inside. this one will be in white.

 

Keel case

The second hull  has been in the construction, photo shows the middle part of the hull, that is opened, the keel case can be seen. I saw on the web page from Kohler design the anti vortex panel that should do the same job as dagger board. I am not sure if i stick to the dagger board or i make anti vortex panels on each hull.

We spent the summer vacations sailing one week in the south of Adriatic coast with small ELAN 19. It is a very nice, good sailing boat if it has good sails.

If you wont to buy a summer house in quiet peaceful bay on island of VIS, here it is, the right choice.

 The second week we spent in a camp Mlaska (bay) on island Hvar.

Small Haka in the background.

I had some nice sailing with the small Haka.